Intellinet 525497 Manual de usuario Pagina 13

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 82
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 12
13
Step 3: Install the upper housing and make sure the housing is well installed.
Step 4: Complete the hardware installation as shown below.
Install PoE Injector
DC: Insert adapter
PoE: This jack is linked to the secondary port of the AP with RJ45.
LAN: This jack is linked to the LAN side of a PC/hub or router/ADSL modem device with RJ45.
There is no software driver or utility installation needed only the configuration settings. Refer to
Chapter 4 for software configuration.
Notice: It will take about 50 seconds to complete the boot-up sequence after powering on. The Power
LED will light, then the WLAN Activity LED will flash to indicate the WLAN interface is enabled and
operational.
Vista de pagina 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 81 82

Comentarios a estos manuales

Sin comentarios